INSTALLATION

Knowing where the fuel hose is located, Activators can be installed during 5 minutes.

    On the car, it is necessary to install at least two Activators (1 set), since the impact of the magnetic fields of one Activator is insufficient.

     The amount of Activators, installed on the vehicle, depends on its fuel consumption (see FUEL CONSUMPTION).

     Activators, applied for all kinds of fuel (GAS, GASOLINE, DIESEL FUEL).

     One Activator consists of two halves which are attached to both sides of the fuel hose and are bolted together with screws and wing nuts.

     The length of the screws provides installation of the Activator on hoses with diameters from 6 mm to 18 mm. The gap between the two halves is the norm. 
     The photo shows examples of installing the Activators under the hood and under the bottom.

 

     Activators are installed in any place of the fuel feed tube (only not on the «return line»).

     Activators ARE INSTALLED on the piping of COPPER, ALUMINUM, RUBBER AND PLASTIC.

Copper fuel hose

Plastic fuel hose

Rubber fuel hose

     On STEEL PIPELINES, Activators ARE NOT INSTALLED (do not pass the magnetic field). To check: if the Activator «sticks» to the pipeline, it must NOT be installed. You see, THERE IS NOTHING COMPLICATED!

     For vehicles with GAS INSTALLATION, they are installed BEFORE the gearbox (until gas is liquid).

 

fuel-supply
How many Activators do you need for your car

ATTENTION! Do not try to put extra Activators — it will only get worse! Example from life: VW GOLF year went with a set of Activators (2 Activators), decided to put another Activator-from the exhaust went gray smoke, put another-went thick black smoke. We removed two extra Activators and everything returned to normal.

When installing Activators on cars, the following standards must be observed:

   For vehicles with a fuel consumption of up to 12 liters per 100 km. requires 1 set of Activators (2 Activators):

   For vehicles with fuel consumption from 12 to 17 liters per 100 km — 1.5 sets of Activators (3 Activators):

   For vehicles with a fuel consumption of more than 17 liters per 100 km — 2 sets of Activators (4 Activators):

For trucks — 3 sets of Activators (6 Activators)

 For other equipment (tractors,bulldozers, combines, etc.) the calculation is based on the ratio — fuel consumption per hour of operation is equal to the mileage of 100 km

 

INSTALACIÓN